Wilmot Auto Repair

You expect your heater/air conditioner to work like it should.  You have a control for temperature and one for fan speed.  You even have a control for what vents the air comes out of.  Don't be surprised one day if your blower fan develops a mind of its own and starts going crazy.  Most of the time, you may find that it starts blowing at full speed, and nothing you do to try to control it does any good.  This is what may be happening. Your blower motor has an electronic component called a resistor.  It does what its name says; it offers resistance.  When you want the fan to run more slowly, you turn the fan speed down.  That resistor accomplishes that by turning its resistance up.  When the resistor fails, the power has nothing to slow it and the fan speeds up.  It's a small part and can fail due to age or corrosion.  It's usually not an expensive part, either, but it's often found in a location that's not that easy for the technic ... read more

The other day, a driver was trying to open his vehicle's hood so he could add some windshield washer fluid.  But when he pulled the hood release inside the car, nothing happened.  Usually, opening any hood is a 2-step process.  You pull the hood release (which is usually a handle under the dashboard to the left of the steering column) and listen for the hood to pop up slightly. (It doesn't open all the way because it has a safety latch to prevent you from accidentally opening it up while you're driving.) Then, you get out and find the latch, usually through the grille near the hood.  There's a little handle on it which you push, slide or pull (there are a few different types) at which point the hood can be opened up all the way.  But in this driver's case, the hood would not release at all when he pulled the handle inside.  Not knowing what to do, he called his service advisor, who told him to bring it over.  The reason? A hood with a broken latch cou ... read more